River table Crystal Clear Epoxy Resin

1. Applicationdescription

Epoxy resin LL-306AB is an epoxy resin adhesive cured under normal temperature and heating conditions, with good fluidity, natural defoaming, anti-yellowing, and odorless. Greenhouse curing or heating curing; wood crafts, jewelry surface glue, furniture, and mold filling and other electronic parts insulation, moisture-proof potting, confidentiality sealing, etc. Do not infuse more than 2cm at a time, and fill the next layer after the thickness is dry.

2. Properties before hardening

Epoxy resin： LL-306A curing agent :LL-306B

Color: colorless and transparent          colorless and transparent

Proportion: 1.15                                    0.96

Viscosity at 25℃: 1000-2000CPS          100MAXCPS

3. Conditions of use

1) Mixing ratio: A: B=100: 33 (weight ratio)

2) Hardening conditions: 25℃×8H-10H(100)；55℃×2H(2g)

3) Usable time: 25℃×30min (100g)

4. Using method

1) Working environment: Please keep the plastic container clean. The components A and B should be proportioned strictly according to the weight ratio, accurately weighed, and fully stirred clockwise along the inner wall of the container, then let it stand for 3-5 minutes before use.

2.)Adjust the amount of glue according to the operating time and amount to avoid waste. When the temperature is lower than 15 ℃, please preheat the A glue to 30 ℃ before adjusting the glue, easy to operate (A glue will thicken when the temperature is low ); The lid must be sealed after use to avoid product scrap due to moisture absorption.

3)When the relative humidity is greater than 85%, the surface of the cured product will easily absorb the moisture in the air and form a white mist. Therefore, when the relative humidity is greater than 85%, it is not suitable for room temperature curing, and it is recommended to use heated curing.

4)The lid must be sealed after use to avoid product scrap due to moisture absorption.

5. Properties after hardening

1) Hardness: shore D <82

2) Withstand voltage: KV/mm 22

3) Bending strength: Kg/mm2 28

4) Volume resistance: Ohm3 1x10*15

5) Surface resistance: Ohmm2 5X10*15

6) Thermal conductivity: W/M.K 1.36

7) Electricity loss: 1KHZ 0.42

8) Heat distortion temperature: ℃ 80

9) Water absorption:% <0.15

10) Compressive strength: Kg/mm2 8.4

The above performance data are typical data measured in a laboratory environment with a temperature of 25°C and a humidity of 70%, and are for customer reference only.